Automatic Edge Milling Machine 6-160mm Milling / Beveling Thickness
Can Do V, X, J Type Beveling On Steel Plate
l The right sketch is the milling and the traveling unit for the
lather, the lower feeding speed is adjusted by inverter, meeting
the requirements of any speed
milling and fast feedback. The upper milling unit has function of
motorized elevating, manual forwarding milling facer, manual
adjusting the milling head angle; the milling facer can adjusting
any position for the work piece milling, so that it can milling the
straighten side and -45°～0；0～45° bevel(adjusted by manual).
TX 32A Milling head
TX-40A Milling head
Max. Part length
Plate width(the machining side is parallel )
0o milling angle is not adjustable
Milling head model
Milling head motor power and revote speed
D=125-320mm(out factory with Ø200 facer )
D=160-400mm(out factory with Ø200 facer )
Main axes revote speed
Milling transverse traveling stroke
Milling free speed
Vfast =5m/mi rapid backing motor driving
Hydraulic powered (about 3.5mpa) or gas cylinder powered (6kg/cm2)
- Rail section is fixed on the lather, Rail is planed into shape with
quality mild steel, and then ground finely and surface quenched,
which ensuring rail precision and abrasion-proof performance.
- Rail is combination of hanging type and horizontal type. Compared
with ordinary hanging type, it boosts stability, reducing vibration
during milling and decrease the noise effectively.
Model of milling-head
- The lather is the welding structure, the whole machine is heat
treated after the machining and gets rid of the stress effectively.
This treatment can make the lather steady without any distortion
and ensure the good precision of the long term using.